DeLonghi Dedica Tamp Station & 51mm Dosing Funnel Set | Made in Australia

Keep your espresso prep tidier with a matching tamp station and dosing funnel for your 51mm DeLonghi Dedica setup.

The dosing funnel gives you more room to add and distribute coffee grounds, helping reduce spills around your portafilter. The tamp station gives your portafilter a dedicated place during preparation. Fine ribbed exteriors bring both pieces together as a coordinated coffee-bench set.

WHAT'S INCLUDED
• 1 × black tamp station
• 1 × black dosing funnel

Two physical, 3D-printed accessories, made in Australia. Portafilter, tamper, coffee machine and other accessories are not included.

TAMP STATION
• Broad front base and fine vertical ribs
• Rounded internal transitions
• Front opening for rinsing and brush access
• Approximately 84mm wide × 130.5mm deep × 65mm high

DOSING FUNNEL
• Compact ribbed design with a wide opening
• Three locating tabs help position the funnel on the portafilter
• Approximately 85mm across the widest point and 30mm overall height
• Nominally 25mm above the portafilter rim when seated flush

COMPATIBILITY
Intended for the original DeLonghi Dedica 51mm portafilter. Aftermarket and bottomless portafilters, baskets and rim profiles can vary. Please check the dimensions and contact us before ordering if you are unsure about your setup.

CARE AND FINISH
Brush out loose grounds after use. If needed, hand-wash briefly with lukewarm water, mild detergent and a soft brush. Rinse thoroughly, drain the station towards its front opening, and allow both pieces to air-dry completely. Avoid dishwashers, boiling water and prolonged soaking or heat.

Fine layer lines and small surface variations are normal features of 3D printing. The two pieces are packed together. Portafilter and other props shown are not included.

Independently made accessories, not affiliated with or endorsed by DeLonghi.