51mm Dosing Funnel for DeLonghi Dedica | Made in Australia

Keep your espresso prep tidier. This ribbed dosing funnel gives you more room to add and distribute coffee grounds, helping reduce spills around your portafilter.

Intended for 51mm DeLonghi Dedica portafilters. 3D printed in Australia in black PETG, with fine vertical ribs.

DETAILS
• One black PETG dosing funnel
• Intended for 51mm DeLonghi Dedica portafilters
• Three locating tabs help position the funnel on the portafilter
• Approximately 85mm across the widest point and 30mm overall height
• Nominally 25mm above the portafilter rim when seated flush
• Approximate product weight: 45 g.
• Physical, 3D-printed accessory

COMPATIBILITY
Portafilter and basket profiles can vary, particularly with aftermarket parts. Please check the dimensions and contact us before ordering if you are unsure about your setup.

CARE
Brush out loose coffee grounds after use. If needed, hand-wash briefly with lukewarm water, mild detergent and a soft brush. Rinse thoroughly and air-dry completely. Hand-wash only; avoid dishwashers, boiling water and prolonged soaking.

FINISH
Fine layer lines are a normal part of 3D printing. Small surface variations may occur between prints.

WHAT IS INCLUDED
One black dosing funnel. Portafilter, tamping station, coffee machine and other accessories are not included.